It takes one to two hours to set up the Aqua Jump for the first time, quicker if there are several people to help or if youâ??ve done it before. This time can also be reduced significantly if the trampoline surface is left assembled during storage and only the tube needs to be inflated for subsequent set ups. On our spring-less (Bongoâ?¢ and O-Zoneâ?¢) products, setup time is only a couple minutes. Without springs or bars, the Bongo and O-Zone products simply require inflating the tube.

 

We highly recommend using an industrial inflator / deflator like the RAVE Hurricane Blower. With this blower, it only takes about 10 to 20 minutes to inflate the Aqua Jump tube, depending on the tube size. You can order this high volume inflator / deflator directly from RAVE Sports by calling 800-659-0790. Using the air output side of a shop vacuum is also an effective way of swiftly inflating the tube, since shop vacuums typically have high air flow rates.

 

We do not recommend the use of an air compressor as over inflation can damage the tube. RAVEâ??s commercial grade products are fully inflated with only 1-2 PSI of air pressure. The high pressure output of most air compressors can easily cause over inflation if not monitored properly during the inflation process. If a compressor is used, be sure not to exceed 2 PSI within the tube.

 

Again, you can use the RAVE Sports Hurricane inflator / deflator or a shop vacuum, positioned in reverse, to swiftly deflate the tube. Another option is to lock the valve open on the tube and let the air naturally flow out of the large opening of the valve.

 

 

The tube material is the same high-grade material used in many ocean-going inflatables and inflatable military boats. Itâ??s a 1000 Denier Polyester with 28 oz. UV treated PVC. All seams are heat-welded for maximum strength and doubled at key stress points. We don not use natural rubber or natural rubber latex in any of our products. Therefore, people with allergic reactions to latex should not have any problems using our products.

 

Yes, the Aqua Jump can be used in the ocean and other salt water locations. In addition to the UV-treated material, the Aqua Jumpâ??s springs, V-rings and tramp frame are made from heavy gauge, hot dipped galvanized steel. Because of the salt-water environment, springs may need to be replaced more frequently. Stainless steel components are also used where practical.

 

The tube will retain its brilliance for years because UV inhibitors are specially blended into the chemistry of our PVC materials. We also recommend using 303 Aerospace Protectant as a secondary topical agent (like sunscreen for your skin) to prevent fading and degradation. 303 also restores lost color and luster, making your Aqua Jump vinyl look like new. Periodic (monthly) application of 303 protectant will provide the best results.

 

Most people leave their Aqua Jump in the water for the season. There are two things to consider: 1) your local regulations regarding anchoring and 2) if the area is consistently exposed to high winds. In those parts of the world where the water never freezes, the Aqua Jump can be left in all year.

 

You should anchor your Aqua Jump in at least 10 feet of water in an area at least 30 feet from any docks, boats or other obstructions.

 

Sufficient anchoring methods will vary depending on your local conditions (ex. Water depth, type of water bottom, exposure to high winds or water current, etc.). Please consult with local authorities (ie. Dock and lift dealerships, marinas or your local water enforcement officials) to understand proven anchoring methods or anchoring restrictions in your area. A heavy duty harness is included with your Aqua Jump. The anchoring method you select should attach to the swivel ring on this harness.

 

You should enlist two or three people to help you lift and carry the smaller Aqua Jumps from land to water, and four to five people for the largest Aqua Jump. DO NOT DRAG. RAVE doesnâ??t recommend towing the Aqua Jump on the water, although it can be transported at very low speeds.

 

The Aqua Jump was not designed for use on land. Like any inflatable product, the Aqua Jump tube should not be exposed to rough edges or sharp objects like rocks and sticks.

 

The bounce height depends on the firmness of tube inflation and weight and strength of the bouncer. It wonâ??t perform exactly like a land trampoline because the water and inflated tube absorb some of the bounce. The trampoline surface is designed so you wonâ??t hit the water below, even with really big bounces. Some water may splash up, however, from the wave action caused by the tube.

 

The size of the Aqua Jump is not related to the bounce height.

 

Most areas do not require any special permits, however, you should check with your local authorities or DNR to determine permit requirements in your area.

 

You can locate a leak in an inflated product by spraying the tube with soapy water. When you find the leak and determine the hole size, use a patch from the repair kit and cut a swatch 1 inch wider than the hole. Deflate the product and clean the area around the hole with rubbing alcohol. Apply glue from the repair kit to the patch and the area around the hole. Let the glue dry approximately 2 minutes until it becomes tacky. Stick the glued parts to each other and rub them together using a hard, smooth, flat surface. Let the patch dry for at least 24 hours before inflating. For bigger holes and tears, follow the same procedure but put a patch on the inside as well as the outside.

 

RAVE offers a one-year warranty for defects in material or workmanship. If the product is being used commercially, like at a camp or resort, there is a 6-month warranty.

 

To store the Aqua Jump, you should first clean the entire inflatable with soap and water or other mild cleansers. Do not use petroleum based or vegetable oil based cleaners. After the tube dries, deflate the tube. Roll the tube loosely and place in a vented container. (A large plastic storage container (Rubbermaid or a similar brand) works well to store the tube and keep safe from rodents). Some people prefer to keep the trampoline frame intact and lean it against a wall instead of taking all the pieces apart.

 

The Aqua Jump is the original water trampoline, manufactured by RAVE Sports. We are experienced leaders in this industry and the quality of the product shows it. The Aqua Jump is designed for the rugged wear-and-tear use exhibited by camps and resorts and has:

The Aqua Jump will not sink if the tube is punctured. Enough air accumulates in the tube to keep the Aqua Jump components afloat. A single air chamber also provides even distribution of the air around the full perimeter of the product, even if air pressure gets low.

 

Rodents like muskrats may be attracted to the PVC vinyl of our product. When your tube is on the water, maintaining full air pressure during periods of non-use usually prevents them from being able to get a hold of the vinyl to chew on it. However, the best way to solve the problem of nuisance rodents is to remove the temptation by taking the product out of the water at night. Another option is to make the whole area unattractive to rodents by changing the environment, eliminating food sources along the shoreline and making the area less hospitable to their inhabitance.